Using The Remote Control; Turning On The Power - Yamaha YSP-800 Mode D'emploi

Using the remote control

The control area and the corresponding functions of the
remote control change depending on the currently selected
input source. Press the input selector buttons (TV, STB,
VCR, DVD or AUX) to select an input source and switch
to the operation mode of the corresponding input source.
Press YSP to switch to the operation mode of this unit.
The buttons on the remote control numbered 3 to 9 are
operational only after you press YSP to switch to the
operation mode of this unit.
y
You can control other components by setting the appropriate
remote control codes (see page 82). Once the remote control code
for each input source (TV, STB, VCR, DVD or AUX) is set, see
"Controlling other components" on page 83 for further
information on the specific functions of the available remote
control buttons for each input source. Note that the buttons on the
remote control numbered 3 to 9 have different functions
depending on the currently selected input source.
DVD VCR
1
INPUT1
AUX
2
YSP
5BEAM ST+3BEAM
1
3
STEREO
TARGET
4
MUSIC
7
4
SPORTS
0
V T
CINEMA DSP
CH LEVEL
5
TEST
1 Input selector buttons
2 YSP
3 Beam mode buttons
4 Sound field program buttons
5 Cursor buttons /
6 VOL MODE
7 SURROUND
8 MENU
9 RETURN
STB TV
TV TV
INPUT2 MACRO
INPUTMODE SLEEP
3BEAM
2 3
TV
5 6
MOVIE VOL MODE
6
8 9
OFF
SURROUND
7
+10
MENU
8
ENTER
RETURN
9
/ / , ENTER

Turning on the power

+ +
VOLUME STANDBY/ON
STANDBY/ON
DVD VCR
INPUT1
AUX
1
Press STANDBY/ON on the front panel or on
the remote control to turn on the power of
this unit.
STANDBY/ON
Front panel
2
Press STANDBY/ON on the front panel or on
the remote control again to set this unit to
the standby mode.
Note
When the unit is in the standby mode, only STANDBY/ON on the
front panel or on the remote control is operational, and the other
control buttons on the front panel or on the remote control are not
operational until the power of this unit is turned on.
GETTING STARTED
POWER POWER
AV TV
STB TV
TV
INPUT2 MACRO
or
Remote control
23