Speakers - Yamaha DSP-A2 Mode D'emploi

Speakers

Use speakers with the specified impedance shown on the rear of this unit.
Right
Center speaker
Subwoofer system
How to Connect:
Connect the SPEAKERS terminals to your speakers with the wire of the proper gauge (keep as short as possible). If the
connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct. That is
the + and – markings are observed. If these wires are reversed, the sound will be unnatural and lack bass.
Caution
Do not let the bare speaker wires touch each other or any metal part of this unit. This could damage this unit or the
speakers, or both.
Red: positive (+)
Black: negative (–)
2
1
3
Front effect speakers
Left
CENTER FRONT
CAUTION
SEE INSTRUCTION MANUAL FOR CORRECT SETTING.
A
COUPLER OUTPUT
MAIN CENTER FRONT REAR
( SURROUND )
PRE MAIN
OUT IN
B
SUB
WOOFER
Right
Main speakers B
Loosen the knob.
Insert the bare wire.
[Remove approx. 5mm
(1/4") insulation from
the speaker wires.]
Tighten the knob and
secure the wire.
Rear speakers
Right
Left
SPEAKERS
REAR
( SURROUND )
MAIN
A
CENTER : 4ΩMIN. / SPEAKER
FRONT : 6ΩMIN. / SPEAKER
REAR : 6ΩMIN. / SPEAKER
MAIN A OR B: 4ΩMIN. / SPEAKER
A B : 8ΩMIN. / SPEAKER
CENTER : 8ΩMIN. / SPEAKER
FRONT : 8ΩMIN. / SPEAKER
REAR : 8ΩMIN. / SPEAKER
B
MAIN A OR B: 8ΩMIN. / SPEAKER
A B : I 6ΩMIN. / SPEAKER
SET BEFORE POWER ON
IMPEDANCE SELECTOR
Left
<
China and General models only
Banana Plug connections are also possible. Simply insert the
Banana Plug connector into the corresponding terminal.
PREPARATION
Right
Main speakers A
>
Left
21