Problem
Disconnected
Your iPod is removed from the Yamaha
iPod universal dock.
Unable to play
This unit cannot play back the songs
currently stored on your iPod.
Bluetooth™
Problem
Searching...
The Bluetooth wireless audio receiver and
the Bluetooth component are in the
middle of the pairing.
The Bluetooth wireless audio receiver and
the Bluetooth component are in the
middle of establishing the connection.
Completed
The pairing is completed.
Canceled
The pairing is canceled.
BT Connected
The connection between the Yamaha
Bluetooth wireless audio receiver and the
Bluetooth component is established.
BT Disconnected
The Bluetooth component is disconnected
from the Yamaha Bluetooth wireless
audio receiver.
Auto Setup (YPAO)
Notes
• If the "ERROR" or "WARNING" screen appears, resolve the problem and then run "Auto Setup" again.
• Warning message "W-2" or "W-3" indicates that the adjusted settings may not be optimal.
• Depending on the speakers, warning message "W-1" may appears even if the speaker connections are correct.
• If error message "E-10" occurs repeatedly, contact a qualified Yamaha service center.
Before Auto Setup
Error message
Connect MIC!
Optimizer microphone is not connected.
Unplug HP!
Headphones are connected.
Memory Guard!
The parameters of this unit are protected.
During Auto Setup
Error message
E-1:NO FRONT SP
E-2:NO SUR. SP
Cause
Cause
Cause
Cause
Front L/R channel signals are not
detected.
Only a signal from one of the surround
channels are detected.
Remedy
Place your iPod in the Yamaha iPod universal dock.
Check that the songs currently stored on your iPod
are playable.
Store some other playable music files on your iPod.
Remedy
Remedy
Connect the supplied optimizer microphone to the
OPTIMIZER MIC jack on the front panel.
Unplug the headphones.
Set "Memory Guard" to "Off."
Remedy
Check the front L/R speaker connections.
Check the surround L/R speaker connections.
Troubleshooting
See
page
16
—
—
See
page
See
page
18
—
45
See
page
11
11
53
En