Usb Playback; Playing Usb Storage Devices; Repeat Play; Random Play - Pioneer X-CM56 Mode D'emploi

USB playback

Chapter 6:
USB playback

Playing USB storage devices

It is possible to listen to two-channel audio using the USB
interface with MP3 files on the front of this receiver.
• Pioneer does not guarantee that any file recorded on a
USB storage device will play or that power will be supplied
to a USB storage device. Also note that Pioneer will accept
no responsibility whatsoever for loss of files on USB
storage devices caused by connection to this unit.
• For details about MP3, see page 35.
1 Press USB as the input source.
"USB" is shown on the main display.
2 Connect the USB storage device.
• This receiver does not support a USB hub.
USB storage device
(commercially available)
3 When the recognition is completed, press
/ to select the folder where the music file is
stored ([ ]), then press
• MP3 track data is called "music file" and the location
they are stored is called a "folder" in this document.
• Repeat this step if there are other folders inside the
selected folder.
• To return to the previous folder, press
4 Press / to select the music file ([ ]), and
then press 1; or ENTER.
• Once play starts, only music files inside the same folder
can be played continuously.
• For details about the basic operations, see page 19.
• When changing to a different input source, stop the
USB memory playback first, before changing.
• Turn the power off before removing the USB storage device.
or ENTER.

or .
Note
• This unit may not recognize a USB storage device, play files
or supply power to a USB storage device. For details, see
When a USB storage device is connected on page 33.
• When a USB storage device is not playing and the unit has
not been operated for 20 minutes or more, the power will
automatically turn off. In this case it is required that the
Auto power off is switched to ON (page 36).

Repeat play

Repeat play can play one track, all tracks or a programmed
sequence continuously.
To repeat one track:
Press repeatedly until "REPEAT ONE" appears. Press
ENTER.
To repeat all tracks:
Press repeatedly until "REPEAT ALL" appears. Press
ENTER.
To cancel repeat play:
Press repeatedly until "REPEAT OFF" appears. Press
ENTER.
Note
• After performing repeat play, be sure to press ∫. Otherwise,
the file of USB storage device will play continuously.
• During repeat play, random play is not possible.

Random play

The file of USB storage device can be played in random
order automatically.
To random play all tracks:
Press RANDOM repeatedly until "RANDOM ON" appears.
Press ENTER.
To cancel random play:
Press RANDOM repeatedly until "RANDOM OFF" appears.
Press ENTER.
Note
• If you press the 9 during random play, you can move
to the track selected next by the random operation.
• In random play, the unit will select and play tracks
automatically. (You cannot select the order of the tracks.)
• During random play, repeat play is not possible.

Switch the display contents

This unit can switch the information recorded in the USB
storage device. For details, see Switch the display contents
on page 20.
06
21
En