Installing The Stand-Alone Electrode Holder; Installing The Power Adapter - OHAUS STARTER 5000 Manuel D'instructions

EN-4
2.2

Installing the stand-alone electrode holder

Install the electrode arm on the base:
After adjusting the tension knob to some extent, the upper arm can be move up and down.
When the pH electrode is placed on the arm and calibration or measurement is being
performed, the storage bottle of pH electrode can be placed into the base hole for easy
storage:
2.3

Installing the power adapter

Insert the adapter plug into the power adapter slot.
CAUTION Only use an adapter plug that is compatible with the mains power
receptacle. Make sure that the adapter plug is fully seated in the power adapter slot
before plugging it into the mains power receptacle.
STARTER 5000 Bench pH Meter