Setup; System Setting; System Setting ►Save Mode; System Setting ►Output - OHAUS STARTER 5000 Manuel D'instructions

EN-14
5

SETUP

5.1

System Setting

System setting is used to set meter parameters, the meter information could also be found in it.
Please see section 3.4 for reference.
System setting ►Save Mode
5.1.1
Save mode has 2 options, one is Auto Save Endpoint Reading, another is Manual Save Endpoint
Reading. Auto Save Endpoint Reading means that when the measurement reaches the endpoint
(auto, manual or time endpoint), the meter will save the endpoint reading automatically.
The Save icon
saved only once.
System Setting ►Output
5.1.2
When selecting shut off connection, the main interface will display the save icon
display the Output Icon
System Setting ► Restore Factory Setup
5.1.3
Restoring the factory setup includes the following:
1. Shut off GLP mode
2. Shut off Auto Save mode
3. Shut off continuous measure
4. Shut off (output) connection
5. Shut off calibration Reminder
6. The resolution is: 0.001pH, 0.01mV
7. Measurement mode: pH
8. Self buffer group will be deleted
9. Baud rate: 9600
10. Brightness of screen: 70%
11. Shut off Screen Protection
12. MTC: 25° C
13. Endpoint: Auto
14. Time endpoint: 10 Second
15. Delete all the calibration data
System Setting ► Service Password
5.1.4
Not used.
will change from black to light grey
.
STARTER 5000 Bench pH Meter
; An endpoint reading can be
, or