Printing - OHAUS STARTER 5000 Manuel D'instructions

STARTER 5000 Bench pH Meter
4.4

Printing

STARTER 5000 can print the measurement or calibration data through RS232. After the printer
(e.g. OHAUS SF-40A) is connected to the meter properly, make the following settings(See 5.1):
please order the connect cable for ST5000 (P/N 30059316) to connect SF40A and ST5000.
System Setting ► Output , select Printer
System Setting ► Baud Rate, select 9600.
The format for the print-out measurement is:
Date Time
6-13-2015 14:20:22
SensorID Endpoint mode
Sensor02 Manual
Temperature Result
25.3° C 6.999pH
The format for the print-out calibration data is:
Calibration Data
SensorID Serial Number
Sensor02 14060012
Cal. Date Cal. Time
01-01-2015 14:20:33
Buffers mV
4.00pH 176.94mV
7.00pH 0.05mV 0.05mV 98.22%
When performing continuous measurement, the format for the print-out calibration data is:
Timing Measure Record
SensorID Serial Number
Sensor03 14060012
Date Time
01-01-2015 14:20:25
Date Time
01-01-2015 14:20:30
Date Time
01-01-2015 14:20:35
User SampleID
User01 Sample02
MTC/ATC
ATC
ATC/MTC
ATC
Offset Slope
Temperature
23.5° C
Temperature
23.5° C
Temperature
23.5° C
Measurement
6.998pH
Measurement
6.999pH
Measurement
7.000pH
EN-13