Installing The Stand-Alone Electrode Holder; Installing The Power Adapter - OHAUS STARTER 3100C Manuel D'instructions

EN-6
2.2

Installing the stand-alone electrode holder

Install the electrode arm on the base,
After adjusting the tension knob to some extent, you can move up and down. When the
electrode is installed on the arm, the storage bottle of pH electrode fits into the base hole.
2.3

Installing the power adapter

Insert the right adapter clip into the power adapter slot.
The Ohaus balance power supply is also 12V which could be used for the pH meter.
STARTER 3100C Bench Conductivity Meter