Clamping Face - Shaper SW1-AA Guide D'utilisation

Clamping Face

Lock Screws
A
Vertical Alignment Pins (2x Left, 2x Right)
B
The four Vertical Alignment Pins are marked with this icon:
To extend, rotate the pin counter-clockwise with the 4mm Wrench.
Ensure that the Alignment Pins are extended until snug before using, but do not over-tighten.
Auxiliary Mounting Holes
C
Used to secure custom or project-specific fixtures to the Clamping Face.
Refer to page 29 for more information.
Vertical Clamping T-Slots
D
Use with the Hold Down Clamps when holding work horizontally.
Refer to page 26 for specific dimensions and other compatible clamps.
Clamping T-Slots
E
Use along with the Hold Down Clamps for general workholding.
Refer to page 26 for specific dimensions and other compatible clamps.
Clamping Face Attachment
Attach Clamping Face to Body
F
There are three sets of mounting holes on the front edge of the Workstation
Body. Align the pegs on the back side of the Clamping Face with the middle set
of mounting holes. Insert the Clamping Face and slide it down into place.
For information on mounting positions, see page 6.
Tighten the two Lock Screws
G
rotate the Lock Screws clockwise until snug, but do not over-tighten.
There is a hard limit built into the Lock Screw, but you may not be able
to tighten all the way to that limit. Do not force the Lock Screws.
SET TinG UP WorkSTATion
9