Custom Fixtures - Shaper SW1-AA Guide D'utilisation

Custom Fixtures

The Workstation can be used as a platform if your project requires a more custom
fixturing solution. The Clamping Face provides a base reference as well as mounting
points to help you align and clamp oddly shaped or non-rectilinear parts.
Use the Vertical Alignment Pins for registration
A
A slip fit over these pins will establish vertical registration to the Clamping Face.
Use the Auxiliary Mounting Points to fasten
B
your fixture to the Clamping Face
Mounting holes are threaded M8 Coarse (M8 x 1.25).
Hole Pattern
The hole pattern information can be found on page 29.
Get creative
Visit shapertools.com/workstation/start for inspiration.
USinG WorkSTATion
23