Small Piece Fixturing - Shaper SW1-AA Guide D'utilisation

Small Piece Fixturing

The Workstation can be used for fixturing workpieces that do not
have enough surface area to accommodate ShaperTape.
Attach the Shelf to the Clamping Face
See page 12 for instructions.
Affix your workpiece to the Shelf Top
A
Use thin double sided tape or screws to securely affix the workpiece to the Shelf
Top. To ensure good cut quality, it is critical that the workpiece does not move.
You can also make your own Shelf Top. See page 26 for more information.
Configure the Support Bar as a vertical end stop
B
This will make for easy leveling of your workpiece.
See page 11 for instructions.
Adjust the Shelf and lock it
C
A. Move the Lock Handle into the Adjustable position.
B. Slide the Shelf up until your workpiece makes
contact with the Support Bar end stop.
C. Move the Lock Handle into its locked position.
remove the Support Bar end stop.
Replace the Support Bar
D
Optional, skip this step if your material obstructs the Support Bar.
WARNING! Risk of cutting into aluminum. Always be sure to leave room
for your cutter between your workpiece and the Support Bar.
Install and Adjust the Spoilboard
Optional, a Spoilboard is only necessary if you are
cutting beyond the edges of your workpiece.
Adjust the Spoilboard Cams until the Spoilboard is pressed
firmly against the back side of your material.
Be careful to not over-tighten the Cams, as this can move your material out of alignment.
Continue Setup on Origin
Scan, Grid, Place and Cut.
Visit shapertools.com/workstation/start for more information.
USinG WorkSTATion
21