Shaper SW1-AA Guide D'utilisation page 15

Cutting Tenons & Finger Joints
Install the Clamping Face at the appropriate
height setting for your project
Set the Clamping Face lower than the maximum depth of cut for your project.
▲ WARNING! Always double-check your depth of cut so as to not
cut into the Clamping Face!
Extend both of the Vertical Alignment Pins
A
Select the side of the Clamping Face that you will be using and
extend both Vertical Alignment Pins using the 4mm Wrench.
Configure the Support Bar as a vertical end stop
B
This will make it easy to adjust your workpiece height
See page 11 for instructions.
Clamp your stock into the Workstation
C
Ensure the reference edge is pressed against the alignment pins
and the top is in contact with the end stop. Secure your work,
ideally using more than one clamp to ensure a strong hold.
Replace the Support Bar
D
Move the Support Bar back onto the Support Arms. Adjust, leaving clearance
for your cutter between the workpiece and the edge of the Support Bar.
▲ WARNING! Risk of cutting into aluminum. Always be sure to leave room
for your cutter between your workpiece and the Support Bar.
Install and Adjust Spoilboard
E
Spoilboard is only necessary if you are cutting beyond the edges of your workpiece.
A. Adjust the Spoilboard Cams until the Spoilboard is pressed
firmly against the back side of your material.
Be careful to not over-tighten the Cams, as this can move your material out of alignment.
Continue Setup on Origin
Scan, Grid, Place and Cut.
USinG WorkSTATion
15