Angle Fence; Using Workstation - Shaper SW1-AA Guide D'utilisation

Angle Fence

The Angle Fence is primarily intended to be
used as a repeatable angle reference. Common
applications include Angled/Dog-leg Tenons.
Angle Fence
A
The Angle Fence can be used on either the
left or right side of the Clamping Face.
The Angle Fence can also be used to support short
workpieces vertically, when the workpiece is not long
enough to make contact with both Vertical Alignment Pins.
Lock Screw
B
Locks Angle Fence in place.
Upper Vertical Alignment Pin
C
The Angle Fence pivots on this pin.
Lower Vertical Alignment Pin
D
The Angle Fence hard stops at 0° on this pin.
Scale
E
The Scale is marked in 5° increments between 0° – 45°
Angle Fence Attachment
Install the Angle Fence
F
A. Use the 4mm Wrench to extend the upper and
lower Vertical Alignment Pins on the side of
the Clamping Face that you will be using.
Ensure that the Vertical Alignment Pins are extended
until snug before using the Angle Fence.
B. Press the Angle Fence on, aligning the
upper hole on the Angle Fence with
the Upper Vertical Alignment Pin.
C. install the included lock Screw through the slot
on the Angle Fence and into the corresponding
threaded hole on the Clamping Face.

USinG WorkSTATion

13