Support Bar & Support Arms - Shaper SW1-AA Guide D'utilisation

Support Bar & Support Arms
Lock Screw
A
Lock Handles
B
Support Bar Attachment
Attach both Support Arms to the Body
C
The Support Arms attach to the outermost mounting positions on the front of the Body.
Align the clamping peg and pin on the Support Arm with the corresponding
holes on the Body. Insert each Support Arm and slide it down into place.
Tighten the Lock Screws
D
rotate the Lock Screws clockwise until snug, but do not over tighten.
Though there is a hard limit built into the Lock Screw, you may not be
able to tighten all the way to that limit. Do not force the Lock Screw!
Install the Support Bar
E
A. Align the two screws on the underside of the Support Bar
with the openings at the end of both Support Arms.
B. Insert the screws and slide the Support Bar forward along the tracks.
Adjust the Support Bar depending on the needs of your project.
▲ WARNING! Risk of cutting into aluminum. Always be sure to leave room
for your cutter between your workpiece and the Support Bar.
C. Press down on the left and right Lock Handles to lock the Support Bar in place.
Always align the sensor bar on the front edge of Origin's base with the top of
the Support Bar for a successful Z-Touch directly on your workpiece.
Configure as vertical end stop for repeatable clamping
F
A. Insert screws on the bottom of the Support Bar with corresponding slots
on the front edge of the Body. Clamp in place with the Lock Handles.
B. This configuration is useful for aligning Any stock surface with
the top surface of the workstation. Common applications include
working vertically, horizontally or on small stock.
SET TinG UP WorkSTATion
11