Mounting Hole Patterns - Shaper SW1-AA Guide D'utilisation

Mounting Hole Patterns

A Body To Bench
For mounting to any generic bench top, see Mounting Screws in figure 1
∙ Size holes for M6 or ¼-20 threaded inserts.
∙ Visit shapertools.com/workstation/start for more information.
For Mounting to a Festool MFT/3 or MW 1000
∙ See hole pattern here, and instructions on page 7.
B Auxiliary Mounting Holes
∙ The Mounting Holes are threaded M8 Course (M8 x 1.25).
∙ Use 8mm holes for the Vertical Alignment Pins.
∙ Visit shapertools.com/workstation/start for more information.
MAinTEnAnCE & TECHniCAl DATA
~
29