Maintenance & Technical Data; Adjustments - Shaper SW1-AA Guide D'utilisation

Adjustments

Tightening the Shelf Handle
A
∙ If the Shelf is slipping downward when
it is in the Locked position, you may
need to adjust the lock tension.
∙ Use the 4mm Wrench to adjust the screws
located on the back side of the Shelf.
The screws will not need much adjustment. Even a fraction
of a turn has a significant effect on the clamping force.
Tighten each screw in roughly 5 degree increments
and test after each adjustment to ensure that you
do not over-tighten and damage the Shelf Lock.
24
MAINTENANCE & TECHNICAL DATA
Tightening the Support Bar Locks
B
∙ If the Support Bar moves easily when the
locks are engaged, you may need to adjust
the lock tension.
∙ Use the 4mm Wrench to adjust the screws
located on the underside of the Support Bar.
The screws will not need much adjustment. Even a fraction
of a turn has a significant effect on the clamping force.
Tighten each screw in roughly 5 degree increments
and test after each adjustment to ensure that you do
not over-tighten and damage the Support Locks.