Secure Body To Bench - Shaper SW1-AA Guide D'utilisation

Secure Body to Bench

The Shaper Workstation has been
designed to easily attach to any
workbench. See the options below.
Remove the Clamping Face from
the underside of the Body
rotate the Lock Screws counterclockwise
with the included 4mm Wrench and slide
the entire assembly up, then out.
You can reattach the Clamping Face to the
underside of the Body for storage.
Attach the Workstation to
E
any wooden bench top
Use the holes (four total) located in the
flanges on the right and left side of the Body
to permanently attach the Workstation to your
▲ WARNING! For your safety and the stability of the Workstation, do not skip this step.
bench with the provided wood screws. Tighten
screws until snug, but do not overtighten.
Optionally, you can install threaded inserts or bolt
holes. Refer to page 29 for hole pattern details.
Attach the Workstation to a
F
Festool MFT/3 or MW 1000
A. Align the mounting points on the bottom of
the Body with the hole pattern on the top
of your MFT/3 or MW 1000. To attach, use
an M6 x 1.0 x 40mm screw or threaded knob
and an M6 fender washer (not provided).
B. Attach with two FSZ 120 or FS-HZ 160
clamps, using the notch in the flange on
the right and left side of the Body.
See page 29 for more information.
SET TinG UP WorkSTATion
7