Spypoint TINY-W Manuel De L'utilisateur page 21

40
• Automatic print of date, time, temperature and moon phase
on every picture.
• Auxiliary power jack for external 12 volts DC input.
• Optional use of a solar panel SP-12V to maintain the charge
of the lithium battery pack LIT-C-8 (sold separately, refer
to the section "OPTIONS") or the 12 volt battery (sold
separately, refer to the section "OPTIONS")
2.
1.
1. ALK / RECH (switch for battery)
2. SD card slot
3. USB port
4. 12 volts jack
5. External trigger jack
6. TV OUT
7. Removable battery case
3. 4.
POWER (TINY-W CAMERA)
The battery level is shown in the bottom right corner of the
screen when the camera is in "Test" mode. When a single
line remains, the camera will continue to take pictures but we
strongly recommend changing the batteries before they are
empty. (See figure below)
5.
Alkaline batteries
This camera requires the use of 6 AA batteries (1.5V). The
use of alkaline batteries is strongly recommended. Also note
6.
that the voltage of rechargeable AA batteries (1.2V) is
insufficient to power your sPYPOINt camera. During the
7.
installation of alkaline batteries, place the switch inside the
battery case to "ALK" (i.e. alkaline). Insert the batteries in
the battery case as indicated and insert it inside the camera
(see figure below). Exact polarity must be followed. We also
recommend the use of new batteries to ensure maximum
performance of your camera.
Connector
SPY SPY P P INT INT
TM
SPY SPY P P INT INT
TM
Top
TM
41
Connector