Skil PWRCORE 20 IW6739B-00 Guide D'utilisation page 15

To remove the belt clip from the tool:
a. Remove the battery pack from the tool.
b. Use a Phillips head screwdriver (not included) to loosen the screw that attaches the belt clip
to the impact wrench.
c. Remove the screw and the belt clip. Store them in a safe place for future use.
Bit Storage and Strap Fixing
(Fig . 8)
Your tool features an integrated bit holder on
the back of the tool base to conveniently store
a hex bit. There's also a strap fixing area next
to the bit holder to attach a wrist strap.
Installing and Removing the
Impact Socket (Fig . 9)
Your tool is equipped with a quick-change
square drive, making socket installation and
removal quick and easy.
Lock the trigger switch "OFF" by placing the
direction-of-rotation selector in the center
position.
NOTICE: Make sure that the impact socket
and the mounting portion are not damaged
before installing the impact socket.
To install the Impact Socket:
a. Align the square of the impact socket with
the square drive and push the impact socket
onto the square drive until it locks into place.
b. Tap it lightly if required.
To remove the Impact Socket:
a. Simply pull the impact socket off from the square drive.
WARNING
hot after prolonged use.
Wear protective gloves when removing the socket from the tool, or
first allow the impact socket to cool down . The impact socket may be
Fig . 8
Bit Storage
Area
Fig . 9
Impact
Socket
Square
Drive
Strap Fixing Area
15