HP StoreOnce 4900 Manuel D'installation Et De Configuration page 48

then be shown a summary of the configuration and be given the
option to validate it, and then a further option to apply it.
Otherwise, you may continue to add further subnets.
-------------------------------------------------------------
Do you want to configure another subnet?
1 = No (default)
2 = Yes - on a new physical port set
3 = Yes - a new subnet on a new VLAN on the same physical port set
4 = Yes - a new subnet on same VLAN on the same physical port set(IPv4)
-->2
<--Another subnet: Yes - on a new physical port set
Select the type of configuration for this subnet
(Selecting "bonded" here will create a "Port Set" consisting of two separate NICs bonded together) :
1 = Single port (default)
2 = Bonded ports (note ports must be the same speed to bond)
-->2
<--Bonded/Single: Bonded ports (note ports must be the same speed to bond)
Select bond configuration :
1 = eth1, eth2 (1 Gig) (default)
2 = eth1, eth3 (1 Gig)
3 = eth2, eth3 (1 Gig)
4 = eth1, eth2, eth3 (1 Gig)
-->3
<--Bonding: eth2, eth3 (1 Gig)
Select the desired bonding mode :
-----------------------------------------------------------------
Note that if you select bonding mode 6, you will not subsequently
be able to add VLAN networks to this Port Set.
-----------------------------------------------------------------
1 = Mode 1 - Active Passive Bonding (default)
2 = Mode 4 - Link Aggregate Control Protocol (LACP) Bonding
3 = Mode 6 - Active Load Balance Bonding
-->3
<--Bonding Mode: Mode 6 - Active Load Balance Bonding
-------------------------------------------------------------
Portsets with bonding mode 6 may not have VLANs.
-------------------------------------------------------------
Is this subnet on a Virtual LAN?
1 = No (default)
-->1
<--VLAN/Not VLAN: No
Select Static or DHCP addressing :
1 = DHCP (default)
2 = Static
-->2
<--DHCP/Static: Static
Enter an IP address for this network:
-->172.1.1.16
<--Static IP address: 172.1.1.16
Enter network mask or network prefix length :
For IPv4 networks, you may enter either a netmask or a length;
For IPv6 networks, you must enter a network prefix length.
-->255.255.0.0
<--Network mask/length: 255.255.0.0
-----------------------------------------------------
Note that if you intend to select this network as the
default network later on, then you must now specify
an IP address.
If, on the other hand, you do not intend to have a
default network, then you may not specify any
gateways for the system.
-----------------------------------------------------
Enter gateway IP address :
-->172.1.1.1
<--Gateway: 172.1.1.1
Enter domain name :
-->uk.mycompany.net
<--Domain name: uk.mycompany.net
----------------------
Network: subnet_4
48 Configuration réseau, comment utiliser les commandes CLI de StoreOnce