Use And Maintenance - EUROM Fly Away 30 IPX4 Livret D'instructions

Installation
When placing and installing the insect-killer, it is important to take the location of
the device in the room/space into account.
1. Hang the insect-killer centrally in the area; that
way, the ultraviolet light can be dispersed better
and attract insects from the entire area.
2. Hang the insect-killer or a wall or in a corner if
the room/area is not very large.
3. The best height for the insect-killer is 1.5 to 2
metres off the ground, which is the most
common flying height for insects.
4. The insect-killer can be suspended from the
chain or placed on a surface such as a table or
cabinet. Make sure it is on a good stable base.
5. Install your insect-killer in a relatively dark
place , near an electricity socket: not in direct sunlight (windows, doors),
because bright sunlight weakens the insect-killer's radiation power. Artificial light
does not weaken the radiation, but makes it work less well.
6. Do not place the insect killer in the draft. Insects avoid drafts / air
flows. Placing the insect killer in the draft flow will therefore not be
effective.

Use and maintenance

Using for the first time
Make sure that the power socket you intend using is earthed and the correct
voltage (220-240V~50Hz). Start the insect-killer working by plugging the device in.
The insect-killer is operating.
The insect-killer can be kept switched on (24 hours a day) all year round.
Replacing lamps
To replace a worn out UV tube you must remove
the plug from the socket and remove the
collection tray by pulling it out of the side of the
device. Unscrew the 2x2 screws next to the
suspension eyes. Remove the suspension eyes
and top cover. Now unscrew the 2x2 screws on
the front and back of the grill and lift the entire
electrical block with the lights out of grill. Unscrew
the ring around the right and left of the light
fitting. Slide the rubber rings and the plastic rings
away. You can now turn the strip light 90°,
remove it from the fitting and replace it. Install
the lights, rings, grill and tray in their original
positions before using the device again.
10