Installation; Use And Maintenance; Removal - EUROM Fly Away 1600 Livret D'instructions

Installation

When placing and installing the insect-killer, it is important to take the location of
the device in the room/space into account.
1. Place the insect-killer centrally in the room; that way, the ultraviolet light can be
dispersed better and attract insects from the entire area.
2. Place the insect-killer or a wall or in a corner if the room/area is not very large.
3. The best height for the insect-killer is 1.5 to 2 metres off the ground, which is
the most common flying height for insects.
4. The insect-killer can be suspended from the chain or placed on a surface such as
a table or cabinet. Make sure it is on a good stable base.
5. Install your insect-killer in a relatively dark place: not in direct sunlight
(windows, doors), because bright sunlight weakens the insect-killer's radiation
power. Artificial light does not weaken the radiation, but makes it work less well.
6. Do not place the insect killer in the draft. Insects avoid drafts / air flows. Placing
the insect killer in the draft flow will therefore not be effective.

Use and Maintenance

Using for the first time
Make sure that the power socket you intend using is earthed and the correct
voltage (220/240V~50Hz). Start the insect-killer working by plugging the device in
and then setting the ON/OFF switch (O/I) to ON (press in 'I'). The insect-killer is
operating.
Service
For safety reasons, the user may not open the grille. So you may not replace
lamps, the fuse or the starter yourself: consult a certified electrician or other
qualified professional for this.
Cleaning
Regularly empty the collection tray by pulling it out of the appliance. Then empty
and clean it.
Dust and dirt influence the appliance's effectiveness, so regularly clean the
appliance. Switch the appliance off, remove the plug from the socket and remove
the collection tray. If you lay the appliance down, you can remove dust and dirt
from the appliance using e.g. a vacuum cleaner, a duster or a soft brush (not a
metal brush!). Never remove the grille! Do not use moisture or aggressive cleaning
agents in the appliance. You can dust off the outside of the appliance with a soft
cloth.
Possible defects/problems
Check if the plug is placed properly in the socket and that the power supply is in
order. In the case of any other causes, consult a qualified professional. It is strictly
forbidden to open the grille and/or to carry out repairs yourself!

Removal

20