Elc Setting [Elc] - Panasonic GP-US932CSAE Mode D'emploi

2. ELC setting [ELC]

Setting ELC (electronic light control) to ON provides auto-
matic adjustment of the screen brightness. The conver-
gence level of ELC can be specified at "BRIGHTNESS" in
the SEL menu ( page 26).
If bright light such as a spotlight is present in the back-
ground behind a subject, the subject may appear dark.
To eliminate this phenomenon, masking bright areas
allows users to perform backlight compensation to hide
bright areas.
Top screen of SETUP menu
CAMERA ID
ELC
SHUTTER
GAIN
SENS UP
OUTPUT SEL
HDMI OUTPUT
END
"ELC CONT" screen
AREA
PEAK/AVE
RET END
z
Set "ELC" to "ON" and press the [SEL] button.
→ The "ELC CONT" screen appears.
x
Move the cursor to "AREA" and use the [e] or [f]
button to select an area.
The area is selectable from the following:
* The detection areas shown in the drawings below
are not displayed.
ALL (default): The detection
target is the whole area on
the screen.
S CIRCLE: The detection tar-
get is the small circle area
in the center of the screen.
M CIRCLE: The detection tar-
get is the medium circle
area in the center of the
screen.
L CIRCLE: The detection tar-
get is the large circle area
in the center of the screen.
18
** SET UP ** P1
*OFF
*OFF
OFF
OFF
OFF
RGB
YPbPr(422)
** ELC CONT **
ALL
.... .... 4
|
P A
MANU: The detection target is manually specified.
( page 18)
AUTO: Dark areas are automatically masked, and
only bright areas are detected.
c
Move the cursor to "PEAK/AVE" and use the [e] or
[f] button to adjust the detection level.
When the cursor is moved in the "P" direction, the
peak value (maximum value) is detected. When the
cursor is moved in the "A" direction, the average
value is detected.
Manual detection area setting
The detection area is manually specified.
"ELC CONT" screen
** ELC CONT **
AREA
PEAK/AVE
RET END
Mask setting screen
z
Select "MANU" in "AREA" on the "ELC CONT" screen
and press the [SEL] button.
→ The mask setting screen appears.
x
Move the cursor to the area to be masked with use of
the [g], [h], [e] and [f] buttons, and press the
[SEL] button.
→ The masked area is displayed in white.
Note:
• To cancel a masked area, move the cursor to the
area to be canceled and press the [SEL] button.
To cancel all the masked areas, hold down the [e]
and [f] buttons simultaneously for 2 seconds or
more.
c
Hold down the [FREEZE
onds or more after completing masking areas.
→ The "ELC CONT" screen appears again.
*MANU
.... .... 4
|
P A
MENU ] button for 2 sec-