Electronic Shutter Setting [Shutter]; Gain Adjustment [Gain]; Electronic Sensitivity Enhancement Setting [Sens Up]; Rgb/Ypbpr Output Signal Setting [Output Sel] - Panasonic GP-US932CSAE Mode D'emploi

3. Electronic shutter setting
[SHUTTER]
Specifies the electronic shutter speed. The following are
available for the speed:
OFF (default), 1/120, 1/250, 1/500, 1/1000, 1/2000,
1/4000, 1/10000 and MANU
Select "MANU", and then press the [SEL] button. The
"SHUTTER" screen appears to make fine adjustment of
the shutter speed.
"SHUTTER" screen
** SHUTTER **
MANU SET
RET END
The adjusting range is from 2/562 to 552/562.
Note:
• When "SHUTTER" is specified, set "ELC" and "SENS
UP" to "OFF" respectively. ( pages 18 and 19)

4. Gain adjustment [GAIN]

Select a gain control setting from the following:
OFF (default): No gain adjustment
AUTO(L), AUTO(H): Automatic gain adjustment
MANU(L), MANU(H): Manual gain adjustment
Fine adjustment of gain level
The gain can be finely adjusted in both "LOW" and
"HIGH" levels.
z
Select an adjustment method in "GAIN" and press the
[SEL] button.
→ The "GAIN LEVEL" screen appears.
x
Move the cursor to "HIGH" or "LOW" and adjust the
level with use of the [e] and [f] buttons.
"GAIN LEVEL" screen
** GAIN LEVEL **
LOW
HIGH
RET END
552/562
... | ..... 4
– +
........ | 10
– +
Important:
• The "LOW" level cannot be larger than the "HIGH"
level.
• When "SENS UP" is set to "OFF" or "---", "AUTO(L)" is
not available.
• "Manu (L)" and "Manu (H)" are not available when
"SENS UP" is set to "AUTO (x2)", "AUTO (x4)" or
"AUTO (x8)".
5. Electronic sensitivity enhancement
setting [SENS UP]
The magnification of the electronic sensitivity is selec-
table from the following:
OFF (default), AUTO (x2), AUTO (x4), AUTO (x8),
MANU (x2), MANU (x4), MANU (x8)
Note:
• When "MANU (x2)", "MANU (x4)" or "MANU (x8)" is
selected, set "ELC" to "OFF". ( page 18)
• When "GAIN" is set to "OFF" or to a low level, image
may become grainy and unstable. In such a case,
adjust the electronic sensitivity.
• When "SHUTTER" is set to other than "OFF", "---"
appears and the electronic sensitivity enhancement
function is not available. ( page 19)
• When the electronic sensitivity enhancement function
is used, time for CCD readout is elongated to
enhance the sensitivity. Therefore, the residual image
of a moving subject is increased in accordance with
the magnification of the sensitivity.
6. RGB/YPbPr output signal setting
[OUTPUT SEL]
The output signals of the RGB/YPbPr output connector
are specified.
RGB (default), YPbPr
7. HDMI output signal setting [HDMI
OUTPUT]
The output signals of the HDMI output connector are
specified.
YPbPr (422) (default), YPbPr (444), RGB (NOR), RGB
(ENH)
19