Start-Up; Assembly And Disassembly - HEINE EN200 BP Mode D'emploi

START SCREEN
Date and time
Rapid single measurements
Double measurements
Manual measurements
Save
Setting
1.3

START-UP

1.3.1 ASSEMBLY AND DISASSEMBLY

The wall plugs supplied with the product are universal wall plugs and suitable
for most building materials (e.g. concrete, solid brick, brick).
1. Hold the drill template horizontally in place on the desired position and mark the
drill holes. Drill a hole of at least 40 mm deep using a Ø 6 mm drill.
2. Fit wall plugs.
3. Use a suitable screwdriver to tighten the two upper screws with a distance of
approx. 3 mm to the wall.
4. There is a USB port on the rear side. Connect the HEINE USB cord and run the
cable via the housing canal to the outside on the left or right hand side. To do so,
press the cable into the clamping hubs, which act as strain relief.
44/212
MED 113275 2018-02-26