Vacuum Pump & Control Panel - Tribest dynapro DPS-2200 Manuel De Fonctionnement

5. VACUUM PUMP & CONTROL PANEL
HOW TO USE VACUUM PUMP
1
Place the VACUUM PUMP on top of the
CENTER CAP of the LID. Press the ONE-
TOUCH BUTTON on the top to turn it on.
The INDICATOR LIGHT should light up.
NOTES
• Before using the VACUUM PUMP, insert 8 AA batteries and make sure the BATTERY COVER is securely in place.
• Fully charged batteries should last at least 60 cycles.
• The VACUUM PUMP will automatically turn off after 15-45 seconds of use, depending on how full the container is.
• If the silicone seal on the CENTER CAP comes out completely, make sure to reinsert it before your next vacuum blend.
• If your VACUUM PUMP is not pulling a tight seal, please follow the troubleshooting directions on the next page.
HOW TO USE CONTROL PANEL
1:30
1
2
LED Color Indicator
Manual Mode - Blue
Timer Mode - Red
Preset Mode - Violet
(List of its parts on next page)
2
The VACUUM PUMP will automatically turn off
when a tight seal is in place. You may leave it on
or off the top of the blender while in operation.
Start blending by following the general Operating
Instructions on the previous page.
LCD DISPLAY
1
Displays status, blending cycles, and error messages for troubleshooting.
3
MANUAL CONTROL DIAL
2
Control the blending speed. In Manual Mode, rotate this dial to select a speed—
start low. Press the
Start or pause blending at any time by pressing the
4
TIMER CONTROL DIAL
3
Press this to switch between Manual and Timer Modes. Set any time between 5
4
seconds to 5 minutes. Press the
PRESET BUTTONS
4
• Press BLEND to automatically blend for 30 seconds.
4
• Press PULSE to automatically pulse for 30 seconds
• Press COMBO to automatically pulse and then blend for the remainder of the
30 second interval(s).
More Preset Functions
• Each press of a Preset Button will add 30 seconds to the total blending time for
up to 3 minutes. Example: BLEND + BLEND + BLEND = 90 sec. of blending.
• For multiple presets, press any combination of the 3 Preset Buttons, up to 3
times, to create custom programs for common blends. Easily program over
1,000 custom combinations. Example: PULSE + BLEND + COMBO = 90 sec. of
combined pulse, blend, and then pulse/blend.
3
When the blending is done, release the
vacuum by pulling up the tab on the black
silicone seal in the middle of the CENTER
CAP.
Start/Pause Dial to start. Adjust the speed at any time.
Start/Pause Dial to begin the timed cycle.
Start/Pause Dial.
9
EN