Load Label Roll In Tear-Off Mode - Carl Valentin DUOPRINT Mode D'emploi

DuoPrint

Load Label Roll in Tear-off Mode

•
Open the printer cover.
•
Open the printheads (A) by turning the red pressure levers (B) anticlockwise.
•
Remove the optional outside label mounting plate from the unwinder.
•
Load the label roll with inner winding onto the unwinding roll.
•
Attach again the label mounting plate.
•
Lead the label material below the return pulley (D) and the printheads (A).
Pay attention that the label runs through the photocells (F).
•
In order to move the printheads (A) down, turn the red pressure levers (B) in clockwise direction until they lock.
•
The tear off edge (G) is visible in front of the first printhead.
•
Enter the offset value in the menu Print settings/Tear off.
•
Adjust the adjusting ring (E) onto the return pulley (D) and the label guiding (C) to the width of material.
•
Close the printer cover.
98 English