Load Label Roll In Standard Mode; Load Label Roll In Tear-Off Mode - Carl Valentin PICA II Serie Guide De Référence Rapide

Pica II

Load Label Roll in Standard Mode

K
J
I
H
G
F
•
Open the printer cover.
•
Open the printhead (K) by turning the red pressure lever (J) anticlockwise.
•
Remove the outside label mounting plate (A).
•
Load the label roll with inner winding onto the unwinding roll (B).
•
Attach again the label mounting plate (A).
•
Lead the label material below the return pulley (D) and the printhead (K).
Pay attention that the label runs through the photocell (E).
•
In order to move the printhead (K) down, turn the red pressure lever (J) in clockwise direction until it locks.
•
Adjust the adjusting ring (C) of the return pulley (D) to the width of material.
•
Close the printer cover.
Load Label Roll in Tear off Mode
The printer is equipped by default with an integrated tear-off edge (not with option cutter or dispenser).
For an operation with tear-off edge (I) unscrew the two knurled knobs (F) and remove the front plate (G).
68
E D
C
English
A
B