Material Savings - Carl Valentin DUOPRINT Mode D'emploi

DuoPrint
Key:
Customized entry
Key:
Colour processing
Key:
CMI length
Key:
Standard label
Key:
Synchrinization at
switching on

Material Savings

Keys: , , ,
Ribbon save mode
Key:
Label save mode
Key:
Auto feed delay
102
Off: No question appears at the display. In this case the stored default value is printed.
On: The question referring the customized variable appears once before the print start at the
display.
Auto: The questions referring the customized variable and the quantity query appear after
every printed layout.
Auto without quantity query: The question referring the customized variable appears after
every layout without additional query for the quantity.
On: The print is effected on both printheads corresponding to the transferred field attributs.
Off, print to PH1: The print is effected at the front printhead.
Off, print to PH2: The print is effected at the rear printhead.
At both operating modes the field attributs are ignored and all fields are printed on the set
printhead.
If the print is stopped at the rear printhead it could come to a small interruption in the printout.
This is shown as a fine white line onto the label. In order to avoid this matter a value for the
minimal retraction
(0 – 1 mm) can be set. At this value the label material is retracted. At the next print start the
free range is overprinted.
On: If a print order is started without previous definition of label, the standard label is printed.
Off: If a print order is started without previous definition of label, an error message appears in
the display.
Off: The synchronization is disabled, i.e. the measuring and label feed have to be released
manually.
Measure: After switching on the printer, the loaded label is automatically measured.
Label feed: After switching on the printer the label is synchronised to the beginning of label.
For this one or multiple labels are advanced.
,
Off: Optimisation off.
Standard: Maximum optimisation performance, i.e. there is no transfer ribbon loss whilst this
setting is used (except for a safety distance of 1 mm so that the print fields are not printed into
one another).
Settings with which this optimisation can no longer be achieved are not permitted.
Dialogue: The printing process is stopped at a suitable position and the printer waits for further
data. As soon as this data is transferred to the printer, the printing process continues.
At the end of a print job, the printer remains in the above position so that a follow-up print job
can be transferred to the printer without any loss of material.
Press the key to stop the print job. In doing so, the remaining labels of the print job are
completed. Blank labels are fed into the printer until the last completed label has passed the
front printhead.
Auto: After an adjustable time which can be set under the menu item Auto feed delay, the
remaining labels between the two printheads are printed.
Off: The print is only stopped after complete printing of all labels. Slow data connections or
labels with a long generating time can lead to a loss of material. In the dispenser modes is this
mode activated automatically.
Setting of time after that the remaining labels between the printheads were automatically
printed.
Value range: 0 ... 255 seconds
English