KTM TOURATECH TOP CASE Mode D'emploi page 34

6 CHANGING THE LOCKING CYLINDER
6.1
14
Changing the locking cylinder
500659-01
500646-01
500647-01
Removing the locking cylinder
–
Key position 90° to the left.
–
Pull up the locking lever.
–
4
Remove screw with washer
–
bo
Push engaging plate
–
Remove the locking cylinder.
Info
It is essential that the key remains in the locking
cylinder.
Installing the locking cylinder
–
Grease and mount the O-ring
Long-life grease (
–
Position and insert the locking cylinder as shown (engaging
bo
plate must be facing downward).
bo
Engaging plate
–
Pull up the locking lever.
–
Position locking plate
der as shown.
The plate faces to the right.
–
Mount and tighten screw
ded).
Info
The locking plates with notch
needed for the cover's optional lock installation, see
Section 7
5
and locking plate
into the locking cylinder.
bn
(included).
p. 17)
engages.
2
(included) on the locking cylin-
4 5
with washer (both inclu-
3
(included) are
2
.