KTM TOURATECH TOP CASE Mode D'emploi page 36

7 OPTIONAL
16
–
Grease and mount the O-ring
Long-life grease (
–
Position and insert the locking cylinder as shown (engaging
bo
plate
Engaging plate
–
Pull up the locking device.
–
Position locking plate
the locking cylinder as shown.
500660-01
The plate faces to the right and the opening to the
front.
–
Mount and tighten screw
with the Top Case).
–
Key position 90° to the left to open.
–
Key position upward for locking.
500661-01
Removing the locking cylinder
–
Key position 90° to the left.
–
Pull up the locking device.
–
Remove screw
–
Push engaging plate
–
Remove the locking cylinder.
Info
It is essential that the key remains in the locking
500662-01
cylinder.
Info
The steps are the same on both sides.
bn
(included).
p. 17)
must point to the right).
bo
engages.
3
(included with the Top Case) on
4
with washer
4 5
with washer and locking plate
bo
into the locking cylinder.
5
(included
3
.