Table des Matières
Publicité
Janome Jem Gold Instruction Manual
q
w
e
www.toews.com
SECTION II. GETTING READY TO SEW
Connecting Machine to Power Supply
q Power switch
w Machine plug
e Machine socket
r
r Power supply plug
t Wall outlet
Before connecting the power cord, make sure the voltage
t
and frequency shown on the machine conform to your
electrical power.
z Turn the power switch off q.
x Insert the machine plug w into the machine socket e.
c Insert the power supply plug r into the wall outlet t.
v Turn the power switch on q.
NOTE:
While in operation, always keep your eyes on the sewing
area, and do not touch any moving parts such as the
thread take-up lever, handwheel or needle.
Always turn off the power switch and unplug from the
power supply:
Do not place anything on the foot control, otherwise the
machine will run inadvertently.
Operating Instructions (for the U.S.A and
Canada only)
This appliance has a polarized plug (one blade wider
than the other). To reduce the risk of an electric shock,
this plug is intended to fit in a polarized outlet only one
way. If the plug does not fit in the outlet, reverse the
plug. If it still does not fit, contact a qualified electrician
to install the proper outlet. Do not modify the plug in
any way.
Foot Controller Model YC-482J-EC or TJC-150 is used
with this machine.
Controlling Sewing Speed
Sewing speed is varied by the foot control.
The harder you press on the foot control, the faster the
machine runs.
6
CAUTION:
Before connecting the power cord, make sure the
voltage and frequency shown on the machine conform
to your electrical power.
– when leaving the machine unattended.
– when attaching or removing parts.
– when clearning the machine.
Jem Gold Owners Manual/ User Guide
Janome Sewing Machine
Publicité
Table des Matières
