Connecting The Machine To The Power Supply; Controlling Sewing Speed; For Your Safety - Janome 9200D Livret D'instructions

1
1
3
10
5
3 4
2
1
6
1

Connecting the Machine to the Power Supply

Before connecting the machine to the power supply,
make sure the voltage and frequency shown on the
machine conform to your electrical power.
1. Turn off the power switch, and connect the
2
machine plug to the machine socket.
2. Connect the power supply plug to your power
supply.
3. Turn on the power switch.
1
Power switch
2
Machine plug
3
Machine socket
4
Power supply plug
5
Power supply
6
Speed controller

Controlling Sewing Speed

Sewing speed can be varied by the speed controller.
The harder you press on the controller, the faster the
machine runs.
Step on the speed controller with the presser foot
lifter up, and practice controlling the speed.
1
Speed controller

For Your Safety:

While in operation, always keep your eye on the
*
sewing area, and do not touch any moving parts
such as the thread take-up lever, loopers,
handwheel, needle or knives.
Always disconnect the machine from the power
*
supply:
— when leaving the machine unattended.
— when attaching or removing parts.
— when threading or cleaning the machine.
Do not place anything on the foot control, otherwise
*
the machine will start inadvertently.