Palazzetti ELSA LEGNA Généralités - Avertissements - Installation - Entretien page 32

• Insert the Twister Flue into the fire box and pass it through the flue outlet hole until the flange M is in abutment with the
upper face of the fire box aligning the grooves N with the brackets O (Fig. 9.2.5a).
• Turn the Twister Flue clockwise or anti-clockwise and release it so that the brackets O act as a support to it (Fig. 9.2.5b).
M M
• Position the chimney section supplied with the Twister Flue as shown in the figure and siliconate the joint area (Fig. 9.2.5c).
• Refit the flue gas box I and the support with the catalysts.
• Refit the throttle adjusting rod and reposition the steel cable.
• Refit the cements D-C-B
• If it is necessary to recalibrate the bypass valve, follow the instructions in para. 8.4
Product images are purely indicative
32
Fig. 9.2.5a
O O
N N
00 477 7300- 18/02/2019 - PALAZZETTI - PN - Italy
Fig. 9.2.5b
Fig. 9.2.5c