Technical Specifications - CyberPower CPS600E Manuel D'utilisation

The EPS does not perform
expected runtime.
The UPS will not turn on.
Model
Capacity (VA)
Capacity (Watts)
Operation Technology
AC Input
Input Voltage Range
Input Frequency Range
AC Output
Number of Phase
On Battery Typical
Output Voltage
Nominal Output Voltage
Configuration Note
On Battery Output
Frequency
Overload Protection
DC fuse is blown due
to overload.
Batteries are
discharged.
Unit has been
damaged by a surge
or spike.
Batteries are not fully
charged.
Batteries are
degraded.
The on/off switch is
designed to prevent
the damage that
rapidly turns it off and
on.
The unit is not
connected to an AC
outlet.
The battery is worn
out.
Mechanical problem.

TECHNICAL SPECIFICATIONS

AVR ( Single Boost & Single Buck )
0 ~40% LOAD Pure Sine Wave at 230 Vac +/- 5%
40~100% LOAD Trapezoidal Wave at 230 Vac+/- 5%
Configurable for 220 / 230Vac
Servicing of the DC fuse should only be
performed by trained personnel. For more
information on DC fuse replacement,
contact CyberPower Systems.
Recharge the unit for at least 4 hours.
Contact CyberPower Systems about
replacement batteries.
Recharge the battery by leaving the EPS
plugged in.
Contact CyberPower Systems about
replacement batteries.
Turn the EPS off. Wait 10 seconds and
then turn the EPS on.
The unit must be connected to a 220/230V
outlet.
Contact CyberPower Systems about
replacement batteries.
Contact CyberPower Systems via phone or
visit our website at
CPS600E
600VA
420W
170Vac – 270Vac
45~65Hz (auto sensing)
Single Phase
50 / 60 Hz +/- 1%
On Utility: Fuse
www.cpsww.eu