Gewiss CHORUS GW 16 974CB Manuel De Programmation page 68

Common settings for all the control algorithms
USER INSTRUCTIONS
Setting the inertia for speed 3
Press the button key to access value change; after the
access, the current parameter value is displayed. Adjust
using the circular touch slider or the push-button
inertia time of speed 3 of the heating
coil control algorithm (range can be set from 0 to 10
seconds), depending on the type of operation selected. If
the device is configured in ETS, this parameter is visible
only if the fan coil speed number is 3. To confirm the set
value, press the
of the timeout (30 seconds) or pressing the push-button
result in exiting the change page without saving it.
Setting the 2° stage adjustment differential
Press the button key to access value change; after the
access, the current parameter value is displayed. Adjust
using the circular touch slider or the push-button
heating or cooling
stage 2° control algorithm (range can be set from 0,1°C to
2,0°C), depending on the type of operation selected. This
parameter is only visible if the second stage has been
enabled from ETS. To confirm the set value, press the
button key within thirty seconds; expiry of the timeout (30
seconds) or pressing the push-button
the change page without saving it.
68
button key within thirty seconds; expiry
adjustment differential of the
the
or cooling fan
of the
result in exiting