User Instructions; Thermostat Operation Statuses; Normal Operation - Gewiss CHORUS GW 16 974CB Manuel De Programmation

The thermostat has three distinct operation statuses:

- Normal operation

- Parameter setting
- Locate mode for Easy channels
When it is switched on, the thermostat goes into "normal operation" status. Using the
button key, you can switch from one status to the other (the switchover from
"parameter setting" status to "normal operation" status also comes about automatically,
30 seconds after the last pressure on the button keys).
During normal operation, information about the thermostat, humidity (if any) and current time is
displayed.
The back-lighting of button keys and the circular touch slider is activated when the proximity sensor
on the device detects the user approaching the device and automatically deactivates after thirty
seconds of inactivity by the user.

USER INSTRUCTIONS

Thermostat operation statuses

Normal operation
Select the information to be displayed
The display enables the visualisation of information about
measured temperature or relative humidity (if any) or the
current time. By pressing the push-button
to display the various pieces of information mentioned above
in succession. When displaying the relative humidity and the
current time, the thermostat information is at any rate visible,
excluding the measured temperature.
Display stand-by deactivation procedure
In stand-by mode, the display visualises only measured
temperature, relative humidity or current time, depending
on which one was active before stand-by was activated. In
order to set the complete deactivation of the display in stand-
by mode, press any part of the left side of the circular touch
slider for at least 3 seconds; the display visualises "OFF", to
indicate that the display will be deactivated. To reactivate
signalling in stand-by mode, repeat the procedure; in this
case, "On" will be visualised.
47
E
N
G
L
I
S
H
it is possible