Gewiss CHORUS GW 16 974CB Manuel De Programmation page 54

"Advanced" parameters
USER INSTRUCTIONS
Setting the minutes
Press the button key to access value change; after
access, adjust the current value using the circular touch
slider or the push-button.
To confirm the set value, press
seconds; expiry of the timeout (30 seconds) or pressing the
push-button
saving it.
Setting GMT / daylight-saving time
Press the button key to access value change; after the
access, the current parameter value is displayed. Select the
current convention (0 = GMT; 1 = daylight saving time)
through the circular touch slider or the push-button
The parameter is only displayed if the automatic
GMT/daylight saving time change was enabled in ETS. To
confirm the set value, press the
seconds; expiry of the timeout (30 seconds) or pressing the
push-button
saving it.
OFF setpoint setting (building protection)
Press the button key to access value change; after the
access, the current parameter value is displayed. Adjust
using the circular touch slider or the push-button
heating or cooling building protection
, depending on the type of operation selected. To confirm
the set value, press the
seconds; expiry of the timeout (30 seconds) or pressing the
push-button
saving it.
54
button key within thirty
result in exiting the change page without
button key within thirty
result in exiting the change page without
button key within thirty
result in exiting the change page without
.
the
setpoint