Gewiss CHORUS GW 16 974CB Manuel De Programmation page 67

USER INSTRUCTIONS
Setting the inertia for speed 1
Press the button key to access value change; after the
access, the current parameter value is displayed. Adjust
using the circular touch slider or the push-button
inertia time of speed 1 of the heating
coil control algorithm (range can be set from 0 to 10
seconds), depending on the type of operation selected. To
confirm the set value, press the
seconds; expiry of the timeout (30 seconds) or pressing the
push-button
saving it.
Setting the inertia for speed 2
Press the button key to access value change; after the
access, the current parameter value is displayed. Adjust
using the circular touch slider or the push-button
inertia time of speed 2 of the heating
coil control algorithm (range can be set from 0 to 10
seconds), depending on the type of operation selected. If
the device is configured in ETS, this parameter is visible
only if the fan coil speed number is higher than 1. To
confirm the set value, press the
seconds; expiry of the timeout (30 seconds) or pressing the
push-button result in exiting the change page without
saving it.
67
button key within thirty
result in exiting the change page without
button key within thirty
the
or cooling fan
the
or cooling fan
E
N
G
L
I
S
H