Installation Procedures; Electric Connection; Standard Models - Snap-on Equipment CENTER POST T7700G-2S Manuel De L'opérateur

Installation Instructions
iii Installation procedures

Electric connection

C A U T I O N : A N Y I N T E RV E N T I O N O N T H E
ELECTRICAL SYSTEM AND THE CONNECTION
OF A PLUG (WHEN NECESSARY), MUST BE
PERFORMED ONLY BY A QUALIFIED ELECTRICIAN,
I N C O M P L I A N C E W I T H T H E A P P L I C A B L E
STANDARDS AND NATIONAL LAWS AND/OR LOCAL
REGULATIONS.
The standard models of the tyre changers have specifi c

Standard models

electrical specifi cations and are supplied according to
the different power supplies that they will be connected
1Ph - SmartSpeed
to. See tables on the side.
(INVERTER)
The electric motors operate with a voltage tolerance
230 V, 1Ph, 50/60Hz, 16A
equal to more or less 10%.
240 V, 1Ph, 50/60Hz, 16A (NA)
The power supply cable, which is always provided with
the machine, must be fi tted with an adequately sized
200 V, 1Ph, 50/60Hz, 20A (Japan)
type-approved plug, in compliance with the applicable
standards in the destination country.
For the installation technician
The qualifi ed electrician, when fi tting a plug, must refer
to the data clearly set out on the plate found on the
machine electrical cable.
The user must ensure that the electrical system that the
machine is connected to is fi tted with 20 A fuses (25
A for Japan) or alternatively, an equivalent automatic
magneto-thermal switch.
Check that there is an effi cient earthing system.
After the connection, press down the wheel support
rotation control pedal (1, Fig. iii-4) and check that it
rotates clockwise.
Check that the power supply system is fi tted with an
automatic cut off device against overcurrents, with a
differential switch calibrated to 30 mA.
1
smartSpeed
WARNING: ONLY USE TYPE B CIRCUIT BREAKERS.
iii-4
76