Snap-on Equipment CENTER POST T7700G-2S Manuel De L'opérateur page 42

42
5.1-3
5.1-4
Mounting and demounting
5.1.1 Use of the Lifter
CAUTION: IN CASE OF HEAVY WHEELS, USE THE
SUITABLE LIFTER LOCATED ON THE MACHINE
LEFT SIDE
The machine is provided with lifter that brings the wheel
or the rim from the ground to a suitable height to be
fi xed on the machine.
This prevents unnecessary and potentially dangerous
efforts.
Lifter correct use:
Figure 5.1.3
• Roll the wheel or the rim until reaching the lifter
board. It is necessary to place the rim LH drop
centre on the machine outer side.
IMPORTANT!
THE RIM DROP CENTRE, IF ANY, MUST
ALWAYS BE FACING UP, CLOSE TO
THE DEMOUNTING TOOL
(Figure 5.1.4)
• Move up the control pedal of the Lifter (1) by
following the wheel or rim movement with a hand
to ensure stability.
• Once the desired height is reached, release the
pedal.
• Tilt and lay the wheel or the rim on the Wheel
Support Flange.
• Press the Lifter control pedal.
• Release the pedal when the Lifter has reached
the ground.
DO NOT MOUNT AND DEMOUNT THE TYRE WITH
THE LIFTER UP.
(if any)