Snap-on Equipment CENTER POST T7700G-2S Manuel De L'opérateur page 62

R
G
T
62
F
S
6.3
Maintenance
H. Drain water from fi lter 'F' every day by moving
upwards the quick drain element 'S' (Fig. 6-3).
I. Regularly check the oil level in the lubricator. When
adding oil to the lubricator, disconnect the air supply
fi rst and then add oil as needed. Make sure seals are
in place when repositioning the cup.
USE ONLY OILS FOR AIR DEVICES, DO NOT USE
BRAKE FLUID OR OTHER NON RECOMMENDED
LUBRICANTS.
Suggested oils for the fi lter/lubricator unit:
TAMOIL : WHITE MINERAL OIL 15
Ro:SHELL : ONDINA OIL 15
BP : ENERGOL WT3
TOTAL : LOBELIA SB 15
ESSO : MARCOL 82
J. Periodically check the lubricator effi ciency. One drop
(Fig. 6.0-4) falling into the transparent cone 'G' every
4-5 operations of the bead breaker indicates that the
correct amount of oil is being supplied in the system. If
necessary adjust the oil fl ow with screw 'R' (Fig. 6.0-4).
K. If the machine is equipped with a beading unit for
tubeless tyres, drain condensation from the tank daily.
6.1 Storage
In case the machine is not to be used for a long period
of time (6 months) it is necessary to disconnect all
power sources, discharge the bead seater tank (only
GT version), protect all parts that may be damaged,
protect the air hoses that may be damaged by the
drying process.
When putting the machine back in operation, check
fi rst the effi ciency of all previously protected parts,
and check for correct functioning of all devices before
using the machine again.