Air Supply - MW TOOLS CAT030S Mode D'emploi

TOOLS

3.2 Air supply

Warnung biologische
Gefährdung!
WARNING!
To prevent serious injury from explosion:
Use only clean, dry, regulated, compressed air to power this soda blaster. Do not use oxygen,
Vorischt, Gefahr durch
carbon dioxide, combustible gases, or any other bottled gas as a power source for this soda
explosionsgefährliche
Stoffe!
blaster.
1. Incorporate a filter, regulator with pressure gauge, dryer, in-line shutoff valve, and quick coupler for best service.
An in-line shutoff ball valve is an important safety device because it controls the air supply even if
Netzstecker ziehen!
the air hose is ruptured. The shutoff valve should be a ball valve because it can be closed quickly.
Note: An oiler system should not be used with this soda blaster. The oil will mix with the material being propelled, causing
poor results.
Schutzanzug tragen!
2. Attach an air hose to the compressor's air outlet. Connect the air hose to the air valve of the soda blaster. Other
components, such as a coupler plug and quick coupler, will make operation more efficient, but are not required.
Adresse des
WARNING!
Ansprechpartners
To prevent serious injury from accidental operation:
Do not install a female quick coupler on the tool. Such a coupler contains an air valve that will
allow the air tool to retain pressure and operate accidentally after the air supply is disconnected.
Note: Air flow, and therefore soda blaster performance, can be hindered by undersized air supply components. The air hose
must be long enough to reach the work area with enough extra length to allow free movement while working.
3. Close the soda blaster's valves.
4. Close the in-line shutoff valve between the compressor and the soda blaster.
5. Turn on the air compressor according to the manufacturer's directions and allow it to build up pressure until it cycles off. DR4 D
Seite 7
6. Adjust the air compressor's output regulator so that the air output is enough to properly power the soda blaster, but the
output will not exceed the soda blaster's maximum air pressure at any time. Adjust the pressure gradually, while checking
the air output gauge to set the right pressure range.
7. Inspect the air connections for leaks. Repair any leaks found.
8. If the soda blaster will not be used at this time, turn off and detach the air supply, safely discharge any residual air
pressure, and close the valves to prevent accidental operation.
Note: Residual air pressure should not be present after the tool is disconnected from the air supply. However, it is a good
safety measure to attempt to discharge the tool in a safe fashion after disconnecting to ensure that the tool is disconnected and
not powered.
26
CAT030S - NLFREN - v1.0 - 28082017
EN