Air Source; Specific Safety Instructions - MW TOOLS CAT030S Mode D'emploi

CAT030S - NLFREN - v1.0 - 28082017
EN
• Dress properly. Do not wear loose clothing or jewellery. Contain long hair. Keep hair, clothing, and gloves away from
moving parts. Loose clothes, jewellery, or long hair increases the risk of injury to persons as a result of being caught in
moving parts.
• Avoid unintentional starting. Be sure the valve is off before connecting to the air supply. Do not carry the tool with your
finger on the switch or connect the tool to the air supply with the switch on.
• Do not overreach. Keep proper footing and balance at all times. Proper footing and balance enables better control of the
tool in unexpected situations.
• Use safety equipment. A dust mask, nonskid safety shoes and a hard hat must be used for the applicable conditions.
• Always wear eye protection. Wear ANSI-approved safety goggles.
• Always wear hearing protection when using the tool. Prolonged exposure to high intensity noise is able to cause
hearing loss.
• Wear heavy-duty work gloves during use.
Tool use and care
• Use clamps or another practical way to secure and support the work piece to a stable platform. Holding the work by hand
or against the body is unstable and is able to lead to loss of control.
• Do not force the tool. Use the correct tool for the application. The correct tool will do the job better and safer at the rate for
which the tool is designed.
• Do not use the tool if the switch does not turn the tool on or off. Any tool that cannot be controlled with the valve is
dangerous and must be repaired.
• Disconnect the tool from the air source before making any adjustments, changing accessories, or storing the tool. Such
preventive safety measures reduce the risk of starting the tool unintentionally. Turn off and detach the air supply, safely
discharge any residual air pressure, and release the throttle and/or turn the valve to its off position before leaving the work
area.
• Store the tool when it is idle out of reach of children and other untrained persons. A tool is dangerous in the hands of
untrained users.
• Maintain the tool with care. A properly maintained tool is easier to control.
• Check for misalignment or binding of moving parts, breakage of parts, and any other condition that affects the tool's
operation. If damaged, have the tool serviced before using. Many accidents are caused by poorly maintained tools.
There is a risk of bursting if the tool is damaged.
• Use only accessories that are identified by the manufacturer for the specific tool model. Use of an accessory not intended
for use with the specific tool model, increases the risk of injury to persons.
Service
• Tool service must be performed only by qualified repair personnel.
• When servicing a tool, use only identical replacement parts. Use only authorized parts.
• Do not use any lubricants with this tool.
Warnung biologische

Air source

Gefährdung!
• Never connect to an air source that is capable of exceeding 13 bar/200 psi. Over pressurizing the tool may cause
bursting, abnormal operation, breakage of the tool or serious injury to persons. Use only clean, dry, regulated
compressed air at the rated pressure or within the rated pressure range as marked on the tool. Always verify prior to
Vorischt, Gefahr durch
using the tool that the air source has been adjusted to the rated air pressure or within the rated air- pressure range
explosionsgefährliche
Stoffe!
• Never use oxygen, carbon dioxide, combustible gases or any bottled gas as an air source for the tool. Such gases are
capable of explosion and serious injury to persons.

1.3 Specific safety instructions

Netzstecker ziehen!
• The warnings and precautions discussed in this manual cannot cover all possible conditions and situations that may occur.
It must be understood by the operator that common sense and caution are factors which cannot be built into this product,
but must be supplied by the operator.
Schutzanzug tragen!
Adresse des
Ansprechpartners
23
TOOLS