Settings Table (Configuration) - Phoenix Mecano RK ROSE+KRIEGER Powerlift M Memory Notice D'assemblage

7.14 Settings table (configuration)

All the settings which you can perform on lifting columns are described in the following table.
Read 7.13 onwards for instructions on how to perform the settings.
Configurations marked with this symbol can sometimes pose a danger to persons or
damage the lifting columns or other objects if the setting is incorrect.
Code
Decide on the addresses for the connected lifting columns:
0
= Off (if the lifting column is used independently)
113
1
= Master (address of the first lifting column)
2-8
= Slave (addresses of the remaining connected lifting columns)
123
Number of slave controls in the bus system
Default height for the display: set which value is to be shown in the hand switch display
133
with the lifting column moved in.
Start initialisation: Start initialisation run without pulling out the lifting column mains plug
211
beforehand.
Lifting height of the display: Change the height indication in the display.
213
If you set the setting
Decide the switching time: determines the time (in percent/10 minutes), during which the
lifting columns can be moved without interruption.
If you set the switching time e.g. to 20%, the lifting columns can be moved for a maximum
of 2 minutes without interruption. After this, you cannot move the lifting columns until 8
232
minutes have passed.
Note: In the factory setup, the switching time is 100 %, i.e. the lifting columns can be moved
for as long as you like without interruption! Despite this 100%, always observe the swit-
ching time of 15% for the lifting columns!
Changing the position of the decimal point of the height indication in the display:
xxxx xxxx.
311
xxx .x
xx.xx
Description
0
, the height in the display is indicated in % ("
7. Working life
xxxP."
)
67