Place Position On A Hot Key; Drive Up To Stored Position - Phoenix Mecano RK ROSE+KRIEGER Powerlift M Memory Notice D'assemblage

7. Working life

7.8.3 Place position on a hot key

Example: You would like to place the position "50 P." (the lifting column is driven out 50 percent)
in user level 1 on hot key 2.
•
Move the lifting column with the UP or DOWN keys until "50 P." appears in the display.
•
Press the F key until "POS.-" appears in the display.
•
Press hot key II within 5 seconds.
•
You have placed the position on hot key 2.
•
You can now drive up to the position with hot key II.
The selected user level and the stored position are still stored, even after switching off the control.

7.8.4 Drive up to stored position

Example: You want to drive up to the stored position 50P. using the hot key.
The position is placed in user level 1 on hot key 2:
•
Press the F key until the last selected user level appears in the display (e.g. "USE.2").
•
Press hot key I within 5 seconds. "USE.1"appears in the display. You have selected the correct
user level.
•
Press hot key II and keep it pressed until the lifting column has moved into the stored position.
Ensure that nobody is in the vicinity of the lifting column when it is moving.
Therefore, only use the hand switch if you can see the lifting columns - danger - risk
of accident!
If the correct user level is already set (User level 1 in the example), you can drive up to the desired
position without selecting the user level beforehand.
60