Maintenance/Repair - neofeu NCE4 Mode D'emploi

and that there are no faults: condition of the straps, seams, adjustment buckles, D-rings and associated
lanyards. - Ensure that there is no cuts, wear and tear, fraying, incipient fractures, traces of rust or
discoloration and ensure that the markings are readable (identification and/or date of validity). Ensure
that the buckles are clean and that they function properly.
- If there is any doubt on the reliability of the equipment, do not use it without getting the written
authorisation of a person who is authorised to decide on its reuse.
- During assembly with other safety components, check their compatibility and ensure that all of the
recommendations and European standards in force (EN) are applied.
- In particular, ensure that no safety function of any component is affected by the safety function of
another component and that they do not interfere with each other.

MAINTENANCE/REPAIR :

To preserve the properties of this equipment, the maintenance recommendations must be followed:
- The equipment must be cleaned and disinfected only with cold water and a neutral soap; never use
detergents or chemical products.
- Dry in a ventilated area, far from any flame or a direct source of heat.
Any modification or repair is forbidden and this equipment must not be used for any purpose other
than what it has been designed for or pushed beyond its limits. The equipment that has been through
a fall must be destroyed to prevent it from being reused.
PERIODIC EXAMINATION :
- Service life: The equipment is designed to last for several years under normal conditions. The service
life depends on the frequency of use and the circumstances.
- Certain particularly aggressive, marine, siliceous or chemical environments can reduce the service life
of the equipment to only a few uses. In these cases, special care must be taken regarding the protection
and the inspections before use. Ensure that the necessary markings are readable.
- A periodic inspection carried out by a competent inspector is necessary to ensure the safety of the
user, which is connected to the maintenance of the effectiveness and resistance of the equipment. A
mandatory annual inspection will check the condition of the equipment and it can only continue to be
used on obtaining a prior written agreement. As concerns what has been mentioned above, the rough
estimate of the service life of the products, as recommended by the marketing authority, is 10 years.
- Ensure that the identification sheet and the maintenance monitoring table are kept up to date from
the time of the commissioning and during each inspection.
INTERPRETATION OF THE MARKINGS (#6):
Identification label :
- 1 PPE reference.
- 2 Serial N°.
- 3 Date of manufacture.
- 4 Expiry date.
- 5 Pictogram size in centimetres of the belt
and the maximum rated load of the belt (#3).
- 6 Pictogram requiring that the instructions be
read before use.
This product is compliant with Regulation 2016/425. It meets the requirements of harmonized
standard EN 358: 2018. The declaration of conformity is available at : www.neofeu.com.
- 7 Manufacturer's logo.
- 8 Address of the marketing authority
- 9 CE Marking.
- 10 Identification of the notified body that
intervened in the inspection and production
phase.
- 11 Reference standard : year of issue.