Menu A: Set Open Time; Menu H: Stop-A Settings - tormatic B-600 Mode D'emploi

4.9.6 Menu A: Set open time

Only in conjunction with function "Automatic close".
1. Select menu item "A".
ð After approximately 2 seconds, the display flashes and shows the set
value of the operating mode.
2. If desired, adjust the setting with the aid of the OPEN (B) and CLOSE (C) but-
tons.
Value Open time
0 0 s
1 10 s
2 30 s
3 60 s
4 90 s
5 120 s
6 150 s
7 180 s
8 210 s
9 240 s
3. Press the programming button (PROG button) (D).
ð The value "H" is displayed.

4.9.7 Menu H: STOP-A settings

1. Select menu item "H".
ð After approximately 2 seconds, the display flashes and shows the set
value of the operating mode. The factory setting is "0".
2. If desired, adjust the setting with the aid of the OPEN (B) and CLOSE (C) but-
tons.
Value Description
0
1
3. Press the programming button (PROG button) (D).
ð The display shows "0". End of menu (if necessary, continue with power
learning cycle).
Remarks
ENS-S 8200 or Extra 412 (with 8k2 resistor) connected to
STOP-A input (terminal G)
Jumper or ENS-S 1000 connected to STOP-A input (terminal G)
EN - 65