Routing The Antenna; Programming The Drive Head - tormatic B-600 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

4.7

Routing the antenna

Hazardous voltage!
DANGER
Pull out the main plug from the mains socket before you remove
the cover of the drive head.
Having installed the antenna, connect the cover to the drive head
again. Only then reconnect the drive head to the power supply.
Fig. 8: Routing the antenna
1. Remove the service flap at the drive head.
2. Loosen the two screws of the front cover and remove the cover.
3. Take the antenna out of the transport lock and feed it outwards through one
of the upper feed-throughs.
4. Place the cover back onto the housing and screw it down.
5. Reattach the service flap.
NOTICE
When using an external antenna, the shield must be placed on the
adjacent terminal (F).
4.8

Programming the drive head

This section describes the normal programming of the drive head during installa-
tion. Programming the control unit is menu-driven.
• Pressing button (D) opens the menu. The digit on the display (A) indicates the
menu step.
• After approx. 2 seconds, the display (A) starts flashing and the setting can be
changed using buttons (B) and (C).
• Press button (D) to save the setting. The programme automatically moves on
to the next menu step. By pressing button (D) repeatedly, you can skip menu
steps.
• To quit the menu, press button (D) repeatedly until "0" is displayed again or
until the display goes out.
• Outside the menu, button (B) can be used to generate a start pulse.
Information on further and/or special settings can be found in the chapter "Special
settings".
56 - EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

B-800B-1000

Table des Matières