Mixing The Fuel; Filling The Tank - Ryobi RHT25X60RO Manuel D'utilisation

■ Wrench
■ Operator's manual
WARNING
If any parts are damaged or missing, do not operate this
product until the parts are replaced. Failure to heed this
warning could result in serious personal injury.
WARNING
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modifi cation is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
WARNING
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark
plug wire from the spark plug when assembling parts.
OPERATION
WARNING
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is suffi cient to infl ict serious injury.
WARNING
Always wear safety goggles or safety glasses with
side shields when operating the product. Failure to do
so could result in objects being thrown into your eyes
resulting in possible serious injury.
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
FUELING AND REFUELING
WARNING
Exercise extreme caution when handling fuel. Petrol is
fl ammable and the vapours are toxic and explosive.
English (Original instructions)
■ Use only fuel containers which are approved for petrol.
■ Add fuel before starting the engine. Never remove
■ Do not smoke.
■ Always refuel outdoors. Never refuel indoors or in a
■ Wipe spilled fuel from the product. Move 9 m away

MIXING THE FUEL

See fi gure 2.
■ This product is powered by a 2-stroke engine and
■ This engine is certified to operate on unleaded petrol
■ Do not use any type of pre-mixed petrol/lubricant from
■ Use synthetic 2-stroke lubricant only. Do not use
■ Mix 2% synthetic 2-stroke lubricant into the petrol. This
■ Mix the fuel thoroughly and also each time before
■ Mix in small quantities. Do not mix quantities larger

FILLING THE TANK

■ Always refuel outdoors in a well-ventilated area away
■ Clean
■ Loosen fuel cap slowly to release pressure and to
■ Clean and inspect the gasket.
■ Carefully pour fuel mixture into the tank. Avoid spillage.
■ Immediately replace fuel cap and hand tighten. Wipe
21
the cap of the fuel tank or add fuel while the engine is
running or when the engine is hot.
poorly ventilated area. Keep away from all sources of
ignition, sparks, and flames.
from refuelling site before starting engine.
requires pre-mixing petrol and 2-stroke lubricant. Pre-
mix unleaded petrol and 2-stroke engine lubricant in a
clean container approved for petrol.
intended for automotive use with an octane rating of
91([R+M]/2) or higher.
fuel service stations, this includes the pre-mixed petrol/
lubricant intended for use in mopeds, motorcycles, etc.
automotive lubricant or 2-stroke outboard lubricant.
is a 50:1 ratio.
fueling.
than the usable in a 30-day period. Synthetic 2-stroke
lubricant containing a fuel stabilizer is recommended.
from sparks, flames, and other ignition sources.
Choose a hard level surface for this task.
surface around
contamination.
keep fuel from escaping around the cap.
up any fuel spillage.
fuel cap to prevent